Samsung Dryers

Samsung DVG55CG7100VA

Model # DVG55CG7100VA

Samsung’s page for the DVG55CG7100VA reads Top Load Gas Dryer Steam Sanitize+ Sensor Dry | 7.4 cu.ft.: a 7.4 cu. ft. gas dryer. The DVG55CG7100VA heats with a gas burner behind the lower front panel, and a flame that lights and then cuts out early is usually the gas valve coils weakening with heat – a failure that is measured, not guessed, once the supply is shut at the appliance valve.

On the DVG55CG7100VA we treat dn as a firmware download in progress and CL as child lock, neither of which is a problem; the real codes – tS, tE, tC, dC, dE, 9C1, FC – are tested with the breaker off and the drum cool before anything is replaced.

Key Features

  • 7.4 cu. ft. drum capacity
  • Gas dryer
  • Steam Sanitize+ cycle
  • Steam refresh cycle
  • Sensor Dry moisture sensing

Most Common Issues on This Model

01

Igniter glowing without a flame

02

9C1 or 9E voltage code at start-up

03

Drum turning with no heat

Error Codes Common to This Model

Own This Model? Book a Diagnosis.

Have the model number to hand when you book, so the technician arrives knowing which parts this model uses and where it usually fails.

Book Your Repair Today

Same-day & next-day appointments · No hidden fees · Technicians trained on these appliances

1Service Details
2Date & Time
3Contact Info

or call (844) 702-1398 now

FAQ

Samsung DVG55CG7100VA FAQ

Treat it as a measurement on the DVG55CG7100VA: Samsung describes C80 as roughly eight-tenths blocked and C90 as more than nine-tenths. With the DVG55CG7100VA switched off and cool, clear the lint screen and its housing, then disconnect the transition hose behind the dryer and check the duct run and the outside hood for packed lint or a flap that will not open. Run the test again once the duct is clear.

On a gas dryer the sequence is igniter, flame sensor, gas valve coils. With the gas shut at the appliance valve and the dryer unplugged, the lower front panel comes off and each is tested in turn - the coils are the usual finding when the flame lights and dies early. Do not open the burner housing with the supply on.

Need a repair? We're ready to help. Call Now
Call Us Schedule