Samsung Appliance Specialists · Licensed & Insured · Serving 5 Major Metro Areas ☎ (844) 702-1398
Appliance Support and Repair Samsung
☎ (844) 702-1398 Schedule a Visit
Samsung Ranges

Samsung NSI6DG9500MT

Model # NSI6DG9500MT

Call (844) 702-1398 Schedule a Visit

Samsung’s page for the NSI6DG9500MT reads Bespoke Slide-in Induction Range Air Fry Wi-Fi | 6.3 cu.ft. – a 6.3 cu. ft. slide-in induction range. The induction zones on the NSI6DG9500MT are driven by power boards that must detect a suitable pan before they heat, and an underlined u over a zone is that pan-detection notice rather than a problem; a zone that stays cold with a known-good pan is a board or coil test.

We say plainly when an older slide-in range like the NSI6DG9500MT is closer to replacement than repair, and we quote a control board only after confirming it is available.

Key Features

  • 6.3 cu. ft. oven capacity
  • Slide-in induction range
  • Air Fry mode with a dedicated tray
  • SmartThings Wi-Fi connection with remote preheat
  • Bespoke finish and trim

Most Common Issues on This Model

01

Display dark after a power interruption

02

Induction zone showing an underlined u

03

C-24 after the oven ran hotter than set

Error Codes Common to This Model

C-24

Samsung Range C-24 Error Code

C-F0

Samsung Range C-F0 Error Code

-dE- / -dC-

Samsung Range -dE- and -dC- (Flex Duo Partition) Error Code

door

Samsung Range door Error Code

u

Samsung Range Underlined u Error Code

tESt / tE5t

Samsung Range tESt and tE5t Display (Not an Error)

Own This Model? Book a Diagnosis.

Have the model number to hand when you book, so the technician arrives knowing which parts this model uses and where it usually fails.

Call (844) 702-1398 Schedule a Visit

Book Your Repair Today

Same-day & next-day appointments · No hidden fees · Technicians trained on these appliances

1Service Details
2Date & Time
3Contact Info

or call (844) 702-1398 now

FAQ

Samsung NSI6DG9500MT FAQ

Pan detection. The NSI6DG9500MT shows an underlined u when the cookware on that zone is unsuitable - the wrong material, too small, or not flat - and refuses to power the coil. Try a pan you know works on induction, centered on the zone; if a known-good pan still triggers the u, the zone’s sensing circuit or power board needs testing.

On the NSI6DG9500MT, Samsung’s range article says a C-10 that appears during self-diagnosis can be ignored if the oven then heats normally. If it also runs cold or uneven, the oven temperature sensor is the part to test, with the breaker off and the rear panel removed.

Need a repair? We're ready to help. Call Now
Call Us Schedule