Samsung Ranges

Samsung NSE6DB850212

Model # NSE6DB850212

Described by Samsung as Bespoke Slide-in Electric Range Air Fry | Wi-Fi 6.3 cu.ft., the NSE6DB850212 is a 6.3 cu. ft. slide-in electric range. The NSE6DB850212 reports oven problems as C-numbered codes – C-10 for the temperature sensor, C-24 for a cavity heating beyond its target, C-F0 for a communication failure between boards – and Samsung notes a C-10 during self-diagnosis can be ignored if the oven then heats normally.

Work on the NSE6DB850212 begins with the breaker off and the oven cool; the rear panel and the control housing come off and the sensor, elements and relays are measured before any part is ordered.

Key Features

  • 6.3 cu. ft. oven capacity
  • Slide-in electric range
  • Air Fry mode with a dedicated tray
  • SmartThings Wi-Fi connection with remote preheat
  • Bespoke finish and trim

Most Common Issues on This Model

01

Oven slow to preheat or under temperature

02

C-10 sensor code after start-up

03

Bake or broil element not glowing

Error Codes Common to This Model

Own This Model? Book a Diagnosis.

Have the model number to hand when you book, so the technician arrives knowing which parts this model uses and where it usually fails.

Book Your Repair Today

Same-day & next-day appointments · No hidden fees · Technicians trained on these appliances

1Service Details
2Date & Time
3Contact Info

or call (844) 702-1398 now

FAQ

Samsung NSE6DB850212 FAQ

On the NSE6DB850212, Samsung’s range article says a C-10 that appears during self-diagnosis can be ignored if the oven then heats normally. If it also runs cold or uneven, the oven temperature sensor is the part to test, with the breaker off and the rear panel removed.

With the breaker for the NSE6DB850212 off and the oven cool, the element is held by two screws at the back wall and two push-on wires, and many owners do change it. Before ordering a part for the NSE6DB850212, though, confirm it has actually failed - a broken or blistered element is obvious, but an element that looks fine and stays cold is usually a relay board or sensor problem, and a new element will not fix that.

Need a repair? We're ready to help. Call Now
Call Us Schedule