Samsung Ranges

Samsung NSE6DG8502MT

Model # NSE6DG8502MT

Samsung’s page for the NSE6DG8502MT reads Bespoke Slide-in Electric Range Air Fry | Wi-Fi 6.3 cu.ft. – a 6.3 cu. ft. slide-in electric range. The NSE6DG8502MT reports oven problems as C-numbered codes – C-10 for the temperature sensor, C-24 for a cavity heating beyond its target, C-F0 for a communication failure between boards – and Samsung notes a C-10 during self-diagnosis can be ignored if the oven then heats normally.

On the NSE6DG8502MT, tESt on the display means demonstration mode and is switched off by the button combination in the owner’s manual, and bAd LinE means the power connection is not fully seated; both are explained before a visit is booked.

Key Features

  • 6.3 cu. ft. oven capacity
  • Slide-in electric range
  • Air Fry mode with a dedicated tray
  • SmartThings Wi-Fi connection with remote preheat
  • Bespoke finish and trim

Most Common Issues on This Model

01

C-F0 communication code between boards

02

C-10 sensor code after start-up

03

C-24 after the oven ran hotter than set

Error Codes Common to This Model

Own This Model? Book a Diagnosis.

Have the model number to hand when you book, so the technician arrives knowing which parts this model uses and where it usually fails.

Book Your Repair Today

Same-day & next-day appointments · No hidden fees · Technicians trained on these appliances

1Service Details
2Date & Time
3Contact Info

or call (844) 702-1398 now

FAQ

Samsung NSE6DG8502MT FAQ

With the breaker for the NSE6DG8502MT off and the oven cool, the element is held by two screws at the back wall and two push-on wires, and many owners do change it. Before ordering a part for the NSE6DG8502MT, though, confirm it has actually failed - a broken or blistered element is obvious, but an element that looks fine and stays cold is usually a relay board or sensor problem, and a new element will not fix that.

On the NSE6DG8502MT, Samsung’s range article says a C-10 that appears during self-diagnosis can be ignored if the oven then heats normally. If it also runs cold or uneven, the oven temperature sensor is the part to test, with the breaker off and the rear panel removed.

Need a repair? We're ready to help. Call Now
Call Us Schedule